RPTR-OBA/734
Installation Manual
REV: B (04/25/2022)
15
6.1.3
INF-1 & Air Horns
1.
Install the fittings (located in the INF-1 Bag) to the INF-1 kit.
For the following step, separate the medium air horn trumpet from the base as shown below.
2.
Install the air valve onto the medium horn driver fitting with the direction of flow (arrow
indicator) pointed towards the air horn driver. The black housing should be oriented as shown
below.
Figure 7- Horn Solenoid Orientation
3.
Install the supplied compression fitting onto the inlet port of the solenoid.
6.2
Tank Brackets
The following brackets & hardware are used in this step:
•
Item 19 = RAPTOR-202 – Qty: 2
•
Item 21 = RAPTOR-210
•
Item 22 = RAPTOR-211
•
Item H1, H7, H9 – Qty: 4 each
•
Item 25 & 26 – Qty: 2 each
Note: Tank straps may come pre-bent, if so, skip steps 6.2.2 Step #3 – 6.2.2 Step #7
6.2.1
Rubber Trim
Trim item 25 & 26 to fit (if needed) and install onto RAPTOR-202 & RAPTOR-210, -211 as shown
in the following figure.
