JT-OBA/220
Kleinn Air Horns
INSTALLATION MANUAL
REV: C (6/25/2021)
29
e.
Follow the frame under the driver’s door and route the
other end of the hose to the compressor.
f.
Use the included 3/8” push
-to-connect elbow fitting (
at the compressor inlet.
g.
Use the zip-tie bracket attached in
to using zip-ties elsewhere) to secure the airline/wires
away from the exhaust.
h.
Trim excess length from the end in the engine bay and
attach compressor intake filter using barb fitting
included in compressor box.
i.
Make your battery connections and follow the firewall over to the air intake. From there,
follow the same route to the compressor.
j.
Use provided self-tapping screw and ring terminal to ground to the frame near this hole. Run
this wire along the hose to the relay. (see 2)
2.
Relay Connection Run (green)
a.
Run wires to/from the relay along the top of the tank
ports. Secure to tank straps and rear of bracket with zip
ties.
3.
Remote Quick Connect Run (cyan)
a.
The QC coupler is mounted in the rear driver-side
corner of the bed (near tail-light and bed hook).
b.
Use the bracket provided with 1302 to determine
location to drill 7/16" hole through side of the truck
bed.
c.
Insert 1/4" grommet in 7/16" hole.
d.
Connect the hose to the QC compression fitting.
e.
The QC is secured to the bracket by sandwich-ing
the bracket between the compression fitting and the
QC coupler.
f.
Temporarily tape over the opening at the other end
of the 1/4” hose to prevent debris from getting in
the hose during routing.
