10
Final Steps & Testing
10.1
Reconnect Vehicle Battery(s)
CAUTION
: Before connecting the vehicle battery(s), verify all
wiring is properly connected and no shorts exists. Use of
Multi-meter, or test light is recommended to check
continuity of all connections.
10.2
Test Air Compressor
1.
Turn the vehicle ignition to the
ON
position and
allow the compressor to fill the air tank. Initial fill
may take approximately 1.5-3 minutes. The air
compressor should shut off automatically once
full pressure is achieved.
2.
If the compressor runs excessively, (i.e., 5
minutes or more) disconnect electrical power to
the air compressor and listen for air leaks in
system. Repair any problems and retest. Contact
Kleinn technical support if problems persist.
3.
Inspect all air line connections (i.e., air tank
fittings, quick connect fittings, air horn fittings,
etc.) for leaks by using a soap and water solution
sprayed directly onto fittings.
4.
System must be pressurized, or at least the air
compressor must be running.
5.
If an air leak is found:
6.
Safely release air pressure from system (i.e.,
slowly open drain valve).
7.
Disassemble leaky connection, re-seal and
reinstall fittings as needed.
10.3
Test Train Horns
1.
Allow the air compressor to run and shut-off
automatically (i.e., air tank is full)
2.
Verify all tubing and electrical wires are securely
fastened to the vehicle, brackets, or kit parts. If
necessary, use extra zip ties to hold tubing and
wire in place.
3.
Ensure all nearby persons have adequate hearing
protection and provide courtesy warning to
neighbors or others in vicinity.
WARNING
: NEVER operate train horns with ears close to
trumpets or in an enclosed space without
(i.e., > Ear Plugs and Earmuffs) for all
persons closer than 100 feet from vehicle. Never
operate train horns outdoors when persons are near
vehicle without adequate hearing protection.
4.
Briefly activate the horns by pressing the horn
button for one (1) second. Repeat three (3) times
with a short rest period between (i.e., 1-3
seconds).
5.
Horns should sound as expected and be loud.
click to listen to example 230 Kit
6.
Horn sound/loudness will taper quickly as the air
tank pressure decreases.
7.
Allow the air compressor to refill the tank, if
needed, and activate the horns for three (3)
second period to ensure the horns are
functioning properly.
10.4
Test Quick Connect Coupler
1.
Allow the air compressor to refill the tank, if
needed.
2.
Attach the supplied INF-1 inflator kit to the quick
connect coupler and verify adequate air pressure
is available
3.
Test fill tires on vehicle, bicycle, etc.
4.
Test air blow gun
5.
Test air impact gun
END OF SECTION
