Kleinn Air Horns JT-OBA, Руководство по установке

Страница: 25 / 36

JT-OBA/220
Kleinn Air Horns INSTALLATION MANUAL
Go to Table of Contents REV: C (6/25/2021) 25
3. Remove factory gas tank skid plate bolt that attaches to this same crossmember. Insert H17 with
washer H18 up through this hole.
4. Secure bracket to crossmember using H18 , H19 , & H20 .
5. Route compressor inlet hose and connect filter.
a. Remove the compressor from its packaging, including hardware and air filter.
b. Review the included directions in the compressor box pertaining to the remote air filter;
select location on vehicle where to mount the air filter, or if desired, filter housing may be
secured to included brackets using zip ties.
c. Use F7 at the compressor inlet. See Section 10 for intake routing.
NOTE: The air filter tubing is rigid and may be difficult to install over barbed & compression
fittings. If necessary, use heat gun at a safe distance to soften the end of the air tubing and
place over fitting. Do not bend tubing excessively and cause it to kink. Use even heat if
necessary, to bend the tubing sharply.
Figure 12: Air Compressor Remote Air Filter & Tubing (shown without Air Compressor)
Air Filter Remote
Mounting Flange
Air Tubing w/Fitting
for Remote Mount
Air Filter Housing