JT-OBA/220
Kleinn Air Horns
INSTALLATION MANUAL
REV: C (6/25/2021)
28
9.2
Disconnect Vehicle Battery(s)
1.
Consult owner’s manual
.
9.3
Suggested Air Hose/Wire Routings
In general, when routing air hose and wires, keep all runs in common areas as much as possible and
branch off as needed. Keep runs away from heat sources and sharp edges as much as possible. Below
is one possible routing solution. Use this guide with the remaining directions to complete your install.
Alternatively, follow the directions below and route as desired.
1.
Air Intake/Battery Connection Run (red/blue)
a.
Open the hood and locate the power steering
fluid reservoir (drivers-side top corner). This is
where the compressor intake filter will sit.
b.
Temporarily tape over the openings at each end
of the 3/8” hose included with compressor to
prevent debris from getting in the hose during
routing.
c.
Locate t
he “Y” in the exhaust (under
driver’s door).
d.
Feed the 3/8" hose up into the hole,
through the frame, and out the frame
hole near the drivers-side front wheel
well (outside wall) and up into the space
shown above.
