User Manual
Klegg Electronics Inc.
6
www.klegg.com
Chapter 2 Cable Installation
Warning
- Do not connect USB cable and Ethernet cable at the same time.
2.1 NDAS Mode
Note:
NDAS Device software
does
need to be installed on each computer in order to use in
NDAS (Ethernet) mode.
NetDisk Mega, NetDisk Giga
1.
If
your NetDisk has dip switches on the rear panel, flip both dip switches down.
2. Connect the included Ethernet cable from the Ethernet port on NetDisk to a fast
Ethernet switch (gigabit Ethernet switch is recommended).
Wireless users:
Connect NetDisk to your wireless router or access point
with included Ethernet cable.
3. Make sure the power connector is firmly attached to the NetDisk and connect the
power adapter to a power source.
4. If your NetDisk has an On/Off switch, slide the On/Off Switch to ON position.
2.2 USB Mode
Note:
NDAS Device software does
not
need to be installed to use in USB mode.
NetDisk Mega and NetDisk Giga
1.
If
your NetDisk has dip switches on the rear panel, flip both dip switches up.
2. Connect the included USB cable from USB port on NetDisk to your PC’s USB port.
3. Make sure the power connector is connected firmly to the NetDisk and connect the
power adaptor to a power source.
4. If your NetDisk has an On/Off switch, slide the On/Off Switch to ON position.
