Klauke TEXTRON HK 12/2 EL, Инструкция по эксплуатации

Страница: 18 / 25

Instruction manual HK12/2EL page 18
_____________________________________________________________________________
The unit is not designed for long continued operation. After approximately 50-60 consecutive
working cycles, respectively 30 min of continued operation, a break of approx. 15 min. is
required to give the unit time to cool down.
Attention
Too intensive use can cause heat damages to the unit
Attention
During the operation of electric engines sparks can occur which might ignite
highly inflammable or explosive liquids and materials
Attention
Electro-hydraulic crimping tools should not be operated in pouring rain or under
water.
The unit can be operated in a temperature range from -20°C to +40°C indoors and outdoors.
5.3. Mounting instructions
If applications other than those mentioned in table 2&3 are intended to be performed with this
tool it is necessary to contact the manufacturer.
Table 3 Marking of the dies
relation
Tab. 2 dies marking
outside
marking
crimping
profile surface of the
dies crimping
width
[mm]
a „Standard type“ CU, „QS“ „QS“ chrome plated,
yellow 10-14
b DIN 46235/
DIN 46267
CU, „QS“,
DIN 46235 code # chrome plated,
yellow 10-14
c Aluminium AL, „QS“ code # blue zinc 5-14
d Compression joint
Aldrey
Al, „QS“ code # blue zinc 12-14
e Compression joint Al, „QS“ code # blue zinc 12-14
DIN 48085 part 3 ST, „QS“ code # black 12
f Pre-rounding dies RU; QS, sm;
QS, sm - chrome plated,
yellow
-
g Terminals
DIN 46234/46230
CU, „QS“,
DIN 46234 QS chrome plated,
yellow
-
h Insulated terminals ISQ, QS QS chrome plated,
yellow -
i Tub. CL for fine-str.
conductors F, QS QS chrome plated,
yellow -
j C-clamps C, QS - chrome plated,
yellow -
k Pre-insulated tub. CL
and connectors IS, QS QS chrome plated,
yellow -
l double compression
CL
DP, QS QS chrome plated,
yellow -
m Oval compression
joints
CU or AL, QS code
number
chrome plated,
yellow -
n AEH DIN 46228 AE, QS - chrome plated,
yellow -
A b b r e v i a t i o n s : C L - t u b u l a r c a b l e l u g s , A E H - c a b l e e n d - s l e e v e s , Q S - C r o s s - s e c t i o n