2-25
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing the range.
Replace all panels before operating range.
Failure to do so can result in death or electri-
cal shock.
REMOVING THE OVEN DOOR
CAUTION:
Do not lift the oven door by its
handle.
WARNING
FIRE HAZARD
Shut off gas supply line valve before servic-
ing the range.
Check all gas line connections and replace
all panels before operating the range.
Failure to do so could result in explosion, fire,
or other injury.
CAUTION:
When you work on the dual fuel
range, be careful when handling the sheet
metal parts. Sharp edges may be present, and
you can cut yourself if you are not careful.
To remove the oven door:
1.
Open the oven door to its fully open posi-
tion.
2.
Install a pin in the hole of each oven door
hinge hanger.
3.
Close the oven door as far as the two pins
will allow.
4.
Grasp the sides of the door and lift the door
until it stops, then pull the hinge hangers
out of the slots.
Door
Pin
Hinge
Hanger
Hinge Hanger
To reinstall the oven door:
1.
Grasp the sides of the door and tilt it back
at a slight angle, then insert the hinge
hangers into the hinge slots as far as they
will go.
2.
Rotate the top of the door towards the
range so the hinge hangers fit onto the
support pins.
3.
Close the oven door as far as the pins will
allow, and make sure that the hinge hang-
ers are fully seated on the support pins. If
they are not seated properly, the door will
not close tightly and may be off-center. To
seat the hinge hangers, open the door
slightly, and push in on the bottom until the
hangers are fully seated.
4.
Open the oven door to its fully open posi-
tion and remove the two hinge hanger
pins.
5.
Close the oven door completely and check
it for proper operation and alignment.
