KitchenAid 9763382, Инструкция по установке, эксплуатации и уходу

Страница: 12 / 32

12
Replacing a halogen lamp
This hood uses four 12-volt, 20 watt halogen lamps.
Turn off the range hood and allow the halogen lamps to cool.
Replace bulb using a tissue to handle bulb, or wearing cotton
gloves. Do not touch bulb with bare fingers.
1. Disconnect power.
2. Remove 2 screws from the circular metal trim around the
lamp assembly.
3. Pull the trim with the lamp assembly attached down far
enough so that the lamp can be pushed out of the socket
clips.
4. Insert the new lamp into the socket clips and push the lamp
and trim assembly back up into the hood.
5. Replace the screws.
6. Reconnect power.
Accessories
Replacement Charcoal Filter........Part Number 8285507
Cleaning and Maintenance
Be sure lights are cool before cleaning the hood.
Exterior surfaces
■
Do not use steel wool or soap-filled scouring pads.
■
Rub in direction of the grain line to avoid marring the surface.
■
Always wipe dry to avoid water marks.
■
KitchenAid ® Professional Formula Stainless Steel Cleaner &
Polish is the cleaner recommended for cleaning stainless steel
surfaces on this product. To order call our Customer Service
Center at 1-800-442-9991 or order on-line at
www.applianceaccessories.com and ask for part number
8171420. To order from Canada, call 1-800-807-6777.
■
If commercial cleaners are used, follow label directions. Do
not use products that contain chlorine (bleach). Chlorine is a
corrosive substance.
For routine cleaning and fingerprints, use liquid detergent soap
and water. Wipe with damp cloth or sponge, then rinse with clean
water and wipe dry.
Metal filters
The filters should be washed frequently. Place metal filters in
dishwasher or hot detergent solution to clean.
To remove metal filters:
NOTE: Use two hands to remove filters, one to pull and turn the
knob, the other to hold the filter so that it doesn’t fall onto the
cooktop.
1. Pull knob forward, toward the front of the hood, while turning
the knob to the left (counter-clockwise) to release the locking
lever.
2. Slide filter down and away from front retaining channel.
To replace metal filters:
NOTE: Use two hands to replace filters, one to pull and turn the
knob, the other to hold the filter so that it doesn’t fall onto the
cooktop.
3. Replace metal filters by first pulling and turning the knob to
the left so that the locking lever does not protrude from the
filter.
4. Insert the opposite end of the filter into the retaining channel.
5. Insert knob end and turn knob to the right to lock the filter
into place.
6. Repeat for remaining filters.
Charcoal Filters - For recirculating installations
The charcoal filters are not washable nor reusable.
They should be changed every 4 months in normal use or more
often if needed.
The charcoal filters capture unpleasant cooking odors.
To replace charcoal filters:
1. Remove the metal grease filters (see “Metal filters” above).
2. Rotate the two metal filter clips toward the filter to release the
charcoal filter. Remove old filter.
3. Reinstall metal grease filter.
RANGE HOOD CARE