NOTICE
Preface
This manual provides detailed information on the Kitagawa NC rotary table so that you can
understand its performance and functions and use it safely and correctly.
Before using this NC rotary table, read this manual carefully to understand how to use it. Always
follow the instructions and warnings given in
“Important Safety Precautions”
and
“Precautions for
Use
”
. Failure to follow these precautions could result in serious injuries.
Terms and Symbols Used for Safety Messages
In this manual, precautions for handling that are considered especially important are classified and
displayed as shown below depending on the damage of risk including the seriousness of the harm that
could result. Please sufficiently understand the meanings of these terms and follow the instructions for
safe operation.
Safety Alert Symbol
This triangle is the safety alert symbol used to alert you to potential safety hazards. To avoid death
or injuries that could occur, follow the safety messages given with this safety alert symbol.
Indicates an Imminently hazardous situation which, If
not avoided, will result in death or serious injury.
Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury.
Indicates instructions which, if not avoided, could result
in damage to the equipment or a shortened work life.
Liability and How to Use this Manual
This unit is installed on the machining centers and suitable for indexing the angle of machining
position of the workpieces. Please contact us if it is used for any other applications.
Kitagawa Iron Works Co., Ltd. shall not be held liable for troubles or accidents that arise from a
failure to observe these safety precautions mentioned in this manual.
This manual does not predict all potential hazards in operation, inspection, and maintenance under
all environmental conditions. There will be an infinite number of matters that cannot or must not be
done, and the manual cannot cover all of them.
Therefore, the matters, unless otherwise mentioned clearly as
“can be done” or “may be done” in
this manual, should be considered as
“cannot be done” or “must not be done”.
Please contact us or our agents if you have any uncertainty about safety when you try to perform
operation, inspection, or maintenance not mentioned in this manual.
Others
The contents of the instruction manual are subject to change without notice for improvement or
specification change.
DANGER
WARNING
CAUTION