Kirk 600v3, Руководство по установке и настройке

Страница: 85 / 205

Configuring KIRK Wireless Server 600v3 85
KIRK Wireless Server 600v3 Installation and Configuration Guide
2
In the Name field, the name MUST ALWAYS be DECT .
If changing the name, the system cannot operate.
3 In the PDW (password) field, type the password, and then type it again in the field below.
4 From the Subscriptions list, select either Allow Anonymous , With User AC only , or
Disabled.
Note: It is recommended to select With User AC only . When subscribing a new handset to
the system it is possible to use an authentication code (AC). If you want to use the
authentication code, you must select
With User AC only . For more information about
subscription of handsets and authentication codes, refer to “Subscribing Handsets” on page
162
5 From the Tones list, select a ring tone.
6 If SIP Protocol: Select the Enbloc Dialing check box.
The Enbloc Dialing check box has to be enabled in a SIP configuration in order for the
handset to collect all digits, before passing them on to a call handler for routing.
Note:
The Enbloc Dialing check box is not to be selected, when using H323 Protocol or
SKINNY Protocol.
7 If H323 Protocol and SKINNY Protocol: Deselect the Local R-Key/Display Handling check
box.
Note: When using SIP Protocol, the Local R-Key/Display Handling check box has to be
enabled to support supplementary services such as On hold and Call transfer .
8
If SIP Protocol: Select the DTMF through RTP channel check box.
The DTMF through RTP channel check box has to be enabled if DTMF tones are needed.
Note:
The DTMF through RTP channel check box is not to be selected, when using H323
Protocol or SKINNY Protocol.
9 From the Coder list, select a voice compression value that matches your telephony
infrastructure.
Contact your system administrator for more information.
10 In the Frame field, type the desired frame length in milliseconds and then select either
Exclusive or SC (Silence Compression).
Contact your system administrator for more information.
Note:
If the Exclusive check box is selected for the coder, then the KIRK Wireless Server
600v3 is forced to use the coder.
11 Click OK .
12 Click Reset (under Administration menu) to save your configuration.