
Configuring KIRK Wireless Server 600v3 135
KIRK Wireless Server 600v3 Installation and Configuration Guide
•
In the
Host Name
field, type the host name of the KIRK Wireless Server 600v3.
The host name consist of
ip1200-
followed by the last three octets of the MAC address of
the KIRK Wireless Server 600v3 (to be found on the label on the rear of the KIRK
Wireless Server 600v3). Eg.
ip1200-0f-01-9d
Note:
When clicking the
Get
button, the system provides the host name automatically.
The
Get
button can only be used, if working online and if the IP address is the specific IP
address of the KIRK Wireless Server 600v3 in question and valid on the whole network.
2
In the
Gatekeeper
area:
•
From the
Mode
list, select
Active
. Selecting
Active
defines the KIRK Wireless Server
600v3 as a Primary (Master).
•
In the
Gatekeeper
field, type the IP address of your call handler.
Contact your system administrator for more information.
•
In the
Alternative Gatekeeper
field, type an alternative IP address of your call handler
(optionally).
Contact your system administrator for more information.
•
From the
Protocol
list, select either
H323
,
SIP
or
Skinny
depending on the protocol you
are using.
3
In the
System
area:
•
In the
AC
field, type an authentication code (optionally).
•
From the
Subscriptions
list, select either
Allow Anonymous
,
With User AC only
, or
Diabled
.
Note:
It is recommended to select
With User AC only
. When subscribing a new handset
to the system it is possible to use an authentication code (AC). If you want to use the
authentication code, you must select
With User AC only
. For more information about
subscription of handsets and authentication codes, refer to
“Subscribing Handsets” on
page 162
.
•
From the
Coder
list, select a voice compression value that matches your telephony
infrastructure.
Contact your system administrator for more information.
•
From the
Tones
list, select a ring tone.
4
In the
LDAP
area:
The Master KIRK Wireless Server 600v3 is automatically defined as the LDAP Server.
If you need to configure a standalone LDAP Server in your system, you must deselect the
Master is LDAP Server
check box.
Note:
If deselecting the
Master is LDAP Server
check box on the
Master
tab, an
LDAP
Server
tab becomes available. For more information about configuring a standalone LDAP
Server, refer to
“Configuring LDAP Server” on page 139
.
Содержание 600v3
