Kirk 600v3, Руководство по установке и настройке, Страница: 23 / 205

Introduction to KIRK Wireless Server 600v3 23
KIRK Wireless Server 600v3 Installation and Configuration Guide
The KIRK Wireless Server 600v3 controls the wireless infrastructure. It manages the KIRK
Repeaters and the IP interface to the call handler, as well as functionalities such as synchronization
of seamless handover, echo cancellation, line delay compensation etc.
The communication protocol between the KIRK Wireless Server 600v3 and the call handler can be
either:
• SKINNY
• H323
• SIP
A KIRK Wireless Server 600v3 is installed directly on the LAN and must be managed as part of
the corporate network.
For more information about the KIRK Wireless Server 600v3, refer to “Deploying KIRK Wireless
Server 600v3” on page 29 , “Installing the KIRK Wireless Server 600v3” on page 39 and
“Configuring KIRK Wireless Server 600v3” on page 73 .
2.1.2 Wireless Bands
The KIRK solution supports two wireless bands, allowing operation in various countries and
regions. Supported wireless bands are:
• ETSI DECT (1880-1900 Mhz), referred to as DECT
• USA DECT (1920-1930 Mhz), referred to as 1G9
The wireless band used by a KIRK Wireless Server 600v3 is determined by the KIRK Wireless
Server 600v3 and KIRK Handsets ordered with the solution.
Table 1 Overview of System Capacity
Description Capacity
Min. number of KIRK Wireless Server 600v3 Single-cell 1
Max. number of KIRK Wireless Server 600v3 Multi-cell 256
Max. number of KIRK Repeaters on KIRK Wireless Server 600v3 Single-cell 6
Max. number of KIRK Repeaters on KIRK Wireless Server 600v3 Multi-cell 1,2 or 3
Max. number of KIRK Repeaters in a whole system 256 (minus number of
KIRK Wireless Server
primaries and secondaries
Max. number of simultaneous calls (Single-cell) 12
Max. number of simultaneous calls (Multi-cell) 11
Max. number of registered KIRK Handsets (Single-cell) 35
Max. number of registered KIRK Handsets (Multi-cell) 1500