Kinoton FP 75 E, Руководство по эксплуатации

Страница: 65 / 81

FP 75 E
Issue: 08/2012
55
6 .4 .5 .3 Adjusting the Pressure of the Skate
• Thread and run a film.
$
The skate lifting is deactivated, the skate presses the film against the
runner strips.
1
3
2
4
• To adjust the skate pressure two adjusting screws

/
Á
are available.
The knurled screw

on the top is suitable for the fine-adjustment.
Via a leaf spring this screw presses against the upper skate suspension and trans-
mits the power for the skate pressure. Furthermore the screw position is used as an
indicator
Â
for the adjusted pressure.
$
The pressure of the skate should be as little as possible, but high enough to assure
a steady picture on the screen. General you can hear if the film skate pressure is
adjusted correctly or not:
- If the pressure is too low the film runs with a bad picture steadiness and a crackled
noise.
- If the skate is adjusted correctly the film runs with an even running noise.
- If the skate is adjusted too strong the film runs with a loud running noise and
the frame steadiness will get worse.
Repair and Adjustments