Kinoton FP 75 E, Руководство по эксплуатации

Страница: 50 / 81

FP 75 E
Issue: 08/2012
40
• Thread the film into the film gate and close the film pressure skate.
One whole frame must be centered vertically in front of the aperture opening.
There is a small light inside the aperture to assist in centring.
Assure the film is centered horizontally between the ceramic discs.
A film loop of about 2 frames must be left both just above and just below the
gate!
If the loops are too big the film will touch stationary parts and be scratched .
If the loops are too small the film may break, the image may jump, or the sound
may warble .
• - Open the sprocket pad shoe.
- Thread the film into the combined holdback/bottom sprocket (all perforations engage
in the sprocket teeth).
- Close the pad shoe.
- Verify the loop below gate is still OK
• Thread the film via the guide rollers to the take-up friction and wind-up the film sev-
eral times around the take-up reel or lead the film to “take-up” level of platter system..
ATTENTION
If the projector was switched off with a threaded film the film loops and the film position
must be checked again.
5 .3 Different Projection Speeds
X
NOTE
Z The xenon lamp will be switched on when the film is running forwards (DIP 7 is
OFF).
If DIP 7 is ON the xenon lamp will ignite at the first projector start and will get off
when projector is switched off.
Z The dowser will be open when projection speed is more than zero.
Z All switching and direction changes are to be done when projector is off.
5 .3 .1 General Keys
Start forwards
Press “in” selects 25 fps (factory-set) - press “out” selects 24 fps (factory-set)
Stop the forward or optional reverse running
Start reverse (optional for projectors with reverse running unit)
Select 24 fps or VARIA speed (optional)