Kinoton FP 75 E, Руководство по эксплуатации

Страница: 47 / 81

FP 75 E
Operation
Issue: 08/2012
37
5 Operation and Troubleshooting
5 .1 Switch on and Start Projector / Stop and Switch off Projector
ATTENTION
Do not stand too close on rotating film spools, because clothes, hair or other parts of
your body can get winded up or trapped into the spools.
Switch on and start the projector
• Switch on the external power supply for the performance room.
• Switch on the main switch (position “I”).
$
The switch illuminates red.
X NOTE
After 10 seconds the microprocessors are initialized, now the projector control takes up
the button commands.
• Thread the film (see chapter 5.2) and do all adjustments either manually or automati-
cally by pushing the corresponding button.
• Push the button .
$
The projector is running, the ventilation is on, the xenon lamp is on.
• If necessary push the button on projector’s operating panel, after the start leader
has run through.
X NOTE
Immediately after projector is switched on you must not manually turn the intermittent
sprocket (e. g. for film threading) until the projector initialization is completed.
Stop and switch off the projector
• Push the button .
$
The dowser closes, the xenon lamp gets off, the projector stops and the ventilation is
on (if temperature is more than 60° C).
• Switch off the main switch (position “0”).
$
The key lamp gets off.
• Switch off the external power supply for the performance room.
X NOTE
If you have an emergency stop, push the main switch (position “0”), to cut the
power.