1011026 User Manual Issue 01 (26.10.2021)
12
8.6.5.
Service
This allows setting the interval between which service alarms occur. The default is 360 days.
Figure 15 Service
8.6.6.
Battery
This displays the battery charger status. The display shows
“
Not Charging
” whe
n mains power is absent. The
charging countdown is paused.
“
Standard charge
”
is displayed when the control unit first has power applied or the internal reset switch is
pressed. This last for 16 hours and a countdown is shown on the display.
“
Intelligent Charge
”
is displayed
when power is interrupted and shows the amount of time until the battery is fully charged.
“
Trickle Charge
”
indicates that the unit is fully charged and maintaining the battery.
8.6.7.
Factory Defaults
This option allows the control unit to be set back to the defaults as they were when the unit left the factory.
The following will be reset with defaults shown in brackets.
•
Unit not activated
•
Country (GB & IRE (Eng.))
•
Timetables (see 10. Default Timetables)
•
Event log (empty log)
•
Service interval (360 days)
•
Inputs (disabled)
•
Blower/motor (blower)
Figure 16 Factory Default
Initially the
“
No
”
option will be highlighted to prevent accidentally setting factory defaults if this was not
intended.
Use the ‘
◄
’ button to move to the Yes option and press the ‘
’ button to confirm. The disp
lay will show:
A few seconds later the unit will restart and prompt for the country to be selected. See section 8.1 Start Up
F a c t o r y D e f a u l t s
Y e s < N o >
R e s t a r t i n g . . .
