EN
38
EN
Product functions
In
more
detail...
FPCSP41-3
Starting / Stopping
NOTE:
When the choke is at OPEN position and the engine speed
gets inconsistent. Then pull the choke slightly out to middle position
to allow additional time for warming up. After warm-up push the choke
back to OPEN position.
13. Hold the product with the left hand on front handle (8) and the right hand on
rear handle (1).
14. Press the throttle interlock (2) and then squeeze throttle trigger (3) to
accelerate the engine. The saw chain runs.
1.
5.
9.
2.
6.
3.
7.
4.
8.
9
23
5
4
27
27
2
3
5
9
CLOSE
OPEN
Fig. 25
Warm start
1. Push front hand guard (9) forward to engage the chain brake (Fig. 25, step 1).
The saw chain is now locked.
2. Set the ignition switch (23) to “1” position (ON position) (Fig. 25, step 2).
3. Pull out the choke lever (5) fully. The choke lever (5) is now at CLOSE position
(Fig. 25, step 3).
4. Push the choke lever (5) fully back in (Fig. 25, step 6). The choke lever is now
at OPEN position, and throttle is kept at the fast tickover position.
5. Hold the product firmly on the ground with left hand on the front handle (8).
Your thumb and fingers shall grasp the handle.
6. Place the right foot onto the rear hand safeguard and step down.
7. Pull the recoil starter handle (27) lightly until you feel resistance then pull it
rapidly (Fig. 25, step 7). Do it again until the engine starts.
8. Press the throttle interlock (2) and the throttle trigger (3) to cancel fast tickover
(Fig. 25, step 8). The engine runs at idle speed.
MNL_Petrol Chainsaw_FPCSP41-3_GB_V02_220301.indd 38
3/2/22 11:36 AM
