Kimaldi FingerVein Online, Инструкция по установке и программированию, Страница: 20 / 69

FingerVein Online
Installation and Programming Manual
www.kimaldi.com Page 20 of 69
$09 Configuration byte of the automatic beeper ena-
bling after a correct Clock&Data reading.
Refer to
Subsection
8.1.4.
$0A Configuration byte of the automatic beeper ena-
bling after an incorrect Clock&Data reading.
Refer to Subsection
8.1.4.
$0B Configuration of the multiread filtering.
Refer to
Subsection
8.1.4.
$0C Time-out in tenths of a second of the multiread fil-
tering, to detect that a card has left the reading
field.
Refer to Subsection
8.1.4.
$0D Configures the communications channel through
which the event frames are sent. (In DB module)
Refer to
Subsection
8.1.2.
$0E Time-out, before starting the biometric sensor.
Refer to Subsection
8.1.2.
$0F
to
$13
Reserved
$14 Time-out of the communication with the display
Refer to Subsection
8.1.6.
$15
to
$19
Reserved
$1A Determines the protocol and Baud Rate assigned
to the UART0-UI. Do not change .
Refer to Subsection
8.1.1.
$1B Determines the protocol and Baud Rate assigned
to the UART1-UI. Do not change .
Refer to Subsection
8.1.1.
$1C Determines the protocol and Baud Rate assigned
to the UART2-UI. Refer to Table 3.
Refer to Subsection
8.1.1.
$1D Do not change
$1E Reserved for future uses.
$1F Time, in tenths of a second, to indicate correct
reading with the green LED.
Refer to
Subsection
8.1.5.