Kimaldi BioMax2, Инструкция по установке и программированию

Страница: 27 / 91

BioMax2 / KBio2-Online
Installation and Programming Manual
www.kimaldi.com Page 27 of 91
is from a Clock&Data port or from a suitably configured UART
(
CFG_Serial_Port_XXXX parameters to value
$40
or
$41
, see
Table 3
).
7.2.2. Online readers
Nevertheless, more sophisticated readers do exist. These are those that can generate an
event with the identification code but that, at the same time, allow for two-way
communications with the Host to be programmed.
Within this type are the Kimaldi readers KRD13M and S42 , which have programmable
automatic modes capable of extracting a data sequence from a Mifare or SLE4442 card,
respectively. In this case, the host may issue instructions to manage reader configuration:
• The data frames are sent via the
Send to UART
instruction.
• The responses are received via the
Reception from UART
event.
• Codetag events (ASCII frames) are received via
Card Reading
.
• The data format is binary, doing without
<STX>, <ETX>.
• Connection via UART0 is established after configuring the
Parameter$1A
CFG_Serial_Port_Host to the value
$40
,
$41
or
$42
, according to the baud rate.
The maximum length of the frame is 48 bytes .
• Connection via UART1 is established after configuring the
Parameter$1B
CFG_Serial_Port_Reader to the value
$40
,
$41
or
$42
, according to the baud
rate. The maximum length of the frame is 48 bytes .
• Moreover, identification events will be treated as in
“Read-only” readers
:
Card
Reading
event, automatic LED and beeper activation, multiread filtering...
7.2.3. Omnikey 55xx Readers
Starting on FW version 0x61.39, Omnikey 55xx Plug&Play RS-232 readers also allow
the
Card Reading
functionality, along with the rest of the features explained in
“Read-
only” readers
. Online, bidirectional communication is also supported.
In order to do that, the following parameters must be configured:
• The corresponding UART (
Parameter$1A
CFG_Serial_Port_Host or
Parameter$1B
CFG_Serial_Port_Reader) to value
$30
or
$31
, according to the
baud rate (see
Table 3
).
• We must also activate the corresponding UART bit at the CFG_Reader_Enable
parameter, and related ones (See
Subsection 8.1.4.
,
Card reading port
configuration
).
• In particular, we must configure
Parameter$0C
CFG_Multiread_TMO (also on
Subsection 8.1.4.
), in order to define the appropriate behaviour of the multiple
Card Reading
events, when the card is permanently placed on the reader.