Kikusui TOS5050A, Руководство по эксплуатации

Страница: 21 / 120

TOS5051A/5050A 2-3
Chap
.2
Installation and Prepar
ation
2.2 Precautions Concerning Installation
Location
This section describes the precautions to be taken when installing the product. Make
sure to observe them.
■
Do not use the tester in a fl ammable atmosphere.
To prevent the possibility of explosion or fi re, do not use the product near alcohol,
thinner or other combustible materials, or in an atmosphere containing such vapors.
■
Avoid locations where the tester is exposed to high tempera-
ture or direct sunlight.
Do not place the product near a heater or in areas subject to drastic temperature changes.
Operating temperature range: 0
°
C to +40
°
C (+32
°
F to +104
°
F)
Storage temperature range: -20
°
C to +70
°
C (-4
°
F to +158
°
F)
■
Avoid humid environments.
Do not place the product in high-humidity locations--near a boiler, humidi fi er, or
water supply.
Operating humidity range: 20 % to 80 % RH (no condensation)
Storage humidity range: 0 to 80 % RH (no condensation)
Condensation may occur even within the operating humidity range. In such case, do
not use the product until the condensation dries up completely.
■
Do not place the tester in a corrosive atmosphere.
Do not install the tester in a corrosive atmosphere or in environments containing sulfuric
acid mist, etc. This may cause corrosion of various conductors and bad contacts of con-
nectors inside the tester leading to malfunction and failure, or in the worst case, a
fi re.
■
Do not place the tester in a dusty location.
Accumulation of dust can lead to electric shock or fi re.
■
Do not use the tester where ventilation is poor.
Secure adequate space around the product so that air can circulate around it.
■
Do not place objects on top of the tester.
Placing objects on top of the tester can cause failures (especially heavy objects).
■
Do not place the tester on an inclined surface or location sub-
ject to vibrations.
The tester may fall or tip over causing damages and injuries.
■
Do not use the tester in a location where strong magnetic or elec-
tric
fi elds are nearby or a location where large amount of distor-
tion and noise is present on the input power supply waveform.
The product may malfunction.