Kikusui KDS6-0.2TR, Руководство по эксплуатации

Страница: 21 / 60

KDS6-0.2TR Names and Functions of Parts 17
2.2 Rear Panel
Fig. 2-2
[11] POWER switch
Turns the power on ( | ) and off (O).
[12] GPIB connector
The connector is used to connect the KDS6-0.2TR to a GPIB controller.
For details on setting the address, refer to 4.1.1, "GPIB Interface."
[13] RS-232C connector
The connector is used to control the KDS6-0.2TR remotely through a computer,
sequencer, or the like using an RS-232C interface. The use of cross-cables enables
communication at a maximum rate of 38400 bps. For information on settings, con-
nection, and other details, refer to 4.1.2, "RS-232C Interface."
[14] FUSE
This is a fuse holder for input power that also serves as a voltage selector.
For details, refer to 1.4, "Checking the Input Power and Fuse."
[15] AC inlet
This is the connector for the power cord. When plugging in the cord, push it in as far
as it can go.
For details, refer to 1.6, "Grounding."
LINE
VOLTAGE
100
120
220
24 0 207V-250V
19 4V-236V
10 4V-126V
90V-110V
FUSE
1A (T)
AC250V
0.5A (T)
AC250V
MARK
FUSE ONLY W I TH 250V FUSE OF THE SPECIFIED
FOR CONTINUED F IRE PROTECTION, REPLACE
WARNING
PROTECT I VE GROUNDI NG CONDUCTOR MUST
BE CONNECTED TO GROUND.
TO AVOID ELECTRIC SHOCK,THE POWER CORD
DO NOT REMOVE COVERS, REFER SERVICING
TO QUALIFIED PERSONNEL.
TYPE AND RATING.
AC LINE
SH1 AH1 T6 TE0 L4 LE0 SR1 RL1 PP0 DC1 DT0 C0 E1
RS232C
GPIB
FUSE
POWER
50/60Hz 40VA MAX
[14] FUSE
[12] GPIB connector
[13] RS-232C connector
[15] AC inlet
[11] POWER switch