KI WorkZone Series, Руководство по сборке

Страница: 8 / 24

8
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
WorkZone
®
Single Universal Overhead Shelf
Assembly Instructions
7. Position the stiffener bar as
illustrated to the lower rear of the
back shelf, align mounting holes
and secure beam to shelf back using
the required number of #8-32 x
1
/
2
”
screws. Also, at each end of the
stiffener beam, use two #10-32 x
1
/
2
”
screws with tooth washers and
secure the beam to the top rear of
the right- and left-hand stanchions
(Figure 8).
8. Orient the back plate as illustrated
behind the shelf, then hang it onto
the back of the cabinet such that the
top vertical flange of the back plate
captures the top inside edge of the
shelf back. Use the two barb clips
provided and press them up at the
underside of the cabinet to attach
the bottom of the back plate to the
bottom, rear of the shelf back
(Figure 8).
9. Take grommets removed in step one
and remove the knock-outs from
each. Snap the grommets back into
place in the grommet hole at the
installed stanchions (Figure 8).
back
plate
#10-32 x /
1
2
"
screw & tooth
washer
#8-32 x /
1
2
"
screw
#10-32 x /
1
2
"
screw & tooth
washer
Figure 8
stiffener
beam
barb clip
WorkZone
Desk
grommet
covers grommet
hole
grommet
knock-out