KI WorkZone Series, Руководство по сборке

Страница: 14 / 24

14
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
WorkZone
®
Dual Universal Overhead Shelf
Assembly Instructions
7. Position the stiffener bar as
illustrated to the lower rear of each
back shelf, align mounting holes
and secure beam to shelf back using
the required number of #8-32 x
1
/
2
”
screws. Also, at each end of the
stiffener beam, use two #10-32 x
1
/
2
”
screws with tooth washers and
secure the beam to the top rear of
the right- and left-hand stanchions
(Figure 14).
8. Orient the back plates as illustrated
behind each shelf unit, then hang
each onto the back of the shelf backs
such that the top vertical flange of
the back plate captures the top inside
edge of the shelf back. Use the two
barb clips provided per shelf unit
and press them up at the underside
of the cabinet to attach the bottom
of each back plate to the bottom,
rear of the corresponding shelf back
(Figure 14).
9. Take grommets removed in step one
and remove the knock-outs from
each. Snap the grommets back into
place in the grommet hole at the
installed stanchions (Figure 14).
Figure 14
back
plate (36 ) "
stiffener
beam
barb clip
back
plate (30 ) "
#10-32 x /
1
2
"
screw & tooth
washer
#8-32 x /
1
2
"
screw
grommet
cover
grommet
hole
grommet
knock-out
WorkZone
Desk