KI WorkZone Series, Руководство по сборке

Страница: 18 / 24

18
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
WorkZone
®
Corner Universal Overhead Shelf
Assembly Instructions
corner overhead
mounting tube
grommet
covers
Figure 19
right-hand
stanchion
left-hand
corner
stanchion
#10-32 x /
1
2
"
screw
#8-32 x /
1
2
"
screw
shelf side
(right-hand)
shelf side
(left-hand)
stanchion
insert (inner)
stanchion
insert (outer)
grommet
hole
#12 x 1 /
3
4
"
screw
Corner Universal Overhead Shelf
Installation
Important: WorkZone corner desk
must be fully assembled prior to
installing the overhead unit.
Note: Determine if your cabinet
installation is specified as right- or
left-hand. This instruction covers
right, though left-hand cabinet
installation is similar but it will have
a different set of stanchions.
1. Begin by removing grommet covers
from the back corner, and back side
at the top of the corner desk where
the overhead cabinet will install
(Figure 19).
2. At the rear corner, from underneath
the worksurface, position the
corner overhead mounting tube as
illustrated and align to pre-drilled
holes. Install using two #12 x 1
3
/
4
”
screws (Figure 19).
3. Reference Figure 19 below to identify
the corner stanchion (left-hand) and
the right-hand stanchion, as well as
the left- and right-hand cabinet sides
(Figure 19).
4. Position the corner stanchion
(left-hand) as illustrated such that
the lower mounting bracket of the
stanchion inserts into the grommet
hole. Align the mounting holes in the
bracket with the holes in the installed
corner overhead mounting tube.
Secure stanchion bracket to corner
overhead mounting tube using two
#10-32 x
1
/
2
” screws (Figure 19).
5. Position the right-hand stanchion
with the bracket through the grommet
hole, aligning the mounting holes
in the bracket with the mounting
holes in the top of the right-hand leg.
Secure bracket to leg using two
#10-32 x
1
/
2
” screws (Figure 19).
6. Orient the right- and left-hand cabinet
sides as illustrated, then nest them
into the tops of the stanchions and
align the mounting holes. Secure
from the inside using two
#8-32 x
1
/
2
” screws at each stanchion
side (Figure 19).