KI WorkZone Series, Руководство по сборке

Страница: 20 / 24

20
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
WorkZone
®
Corner Universal Overhead Shelf
Assembly Instructions
10. Position the stiffener bar as
illustrated to the lower rear of the
back shelf, align mounting holes
and secure beam to shelf back
using the required number of
#8-32 x
1
/
2
” screws. Also, at each
end of the stiffener beam, use two
#10-32 x
1
/
2
” screws with tooth
washers and secure the beam to the
top rear of the right- and left-hand
stanchions (Figure 23).
11. Orient the back plate as illustrated
behind the cabinet, then hang it
onto the back of the cabinet such
that the top vertical flange of the
back plate captures the top inside
edge of the shelf back. Use the two
barb clips provided and press them
up at the underside of the cabinet to
attach the bottom of the back plate
to the bottom, rear of the shelf back
(Figure 23).
12. Take grommets removed in step one
and remove the knock-outs from
each. Snap the grommets back into
place in the grommet hole at the
installed stanchions (Figure 23).
WorkZone
Corner Desk
Figure 23
#8-32 x /
1
2
"
screw
#10-32 x /
1
2
"
screw & tooth
washer
back
plate
stiffener
beam
barb clip
grommet
hole
grommet
knock-out
grommet
cover