Model PW90 90˚ Countertop
4
Two piece mitered surface with 90˚ right angle. To
be used with 36" or 42" high panels. Countertop
extends 4" over the top of the panel to comply with
ADA guideline 4.4.1. Brackets are mounted on
inside of station, include steel locking clips to
prevent dislodgement. Countertop accepts task
light on receptionist side.
Note:
If countertop is installed adjacent to an in-
line height change full post, a notch must
be specified on the left, right or both sides
of the work surface.
Figure 2.
Width: 24", 30", 36"
Depth: 16"
Note:
WireWorks Countertops can be installed
on top of any height panel. Countertops
add 3" to the stated height of the panel; i.e.
a 30" high panel supports a countertop
such that the top of the countertop is 33"
above the floor (assuming that the glides
are turned out 1/2”).
Note:
Brackets are positioned on the receptionist
side of the panel. The aisle side of the
panel remains clear of brackets (except for
wheelchair height countertops).
1. Ensure that countertop is the same width as the
panel(s) to which it will be attached.
2. Ensure that the panel top cap and related trim
is installed prior to attaching the countertop.
Top cap cannot be installed after countertop is
installed.
3. Position the brackets such that the top of the
bracket is slightly (1/8") above the panel top
cap. Note: Brackets are handed and "L" and "R"
are stamped into the top flange of the brackets.
Figure 1.
Note:
A third bracket is required on 90˚
countertop to be installed in corner at
same time and same manner as other
brackets.
Countertop support
lock (L)
Countertop support
bracket (L)
Countertop support
bracket (R)
Countertop support
lock (R)
Figure 1
Countertop support
bracket (Corner)
Panel
Lock
Bracket