Model PWCT Straight Countertop
3
4. Brackets are engaged into the panel by
inserting teeth of bracket into slots of vertical
post and then pushing down to seat. Check for
proper engagement by pulling firmly straight
out.
Note:
Countertops over 60" use three brackets.
5. Locate predrilled holes on underside of
countertop.
6. Place countertop over brackets (installed on
panel). Position countertop such that greatest
amount of overhang is on receptionist side of
panel.
Figure 1.
7. Install one screw in the left and right brackets
in holes closest to receptionist.
8. Insert locking bracket so that the long finger of
the bracket engages into slot of vertical post of
panel and that the hole in the top flange of
locking bracket aligns with the hole in the
countertop bracket (closest to the panel).
Figure 1.
9. Drive in screw through flanges of both brackets
and into pilot hole of countertop.
10. Tighten all four screws.
Countertop used with change of height trim
When the countertop is located next to a taller
panel(s) the countertop must be ordered with one
or two notches to accommodate the end of run trim
of the taller panel(s).
Figure 2.
Note:
To finish the cutout in the countertop, use
the C-shaped grommet. A filler is provided
to cap the grommet if the countertop is
reconfigured to a location without a taller
adjacent panel.
Receptionist
Aisle
C-shaped
grommet
Filler
Notch
Figure 2
