Model PWCTW90 90˚ Wheelchair Height Countertop
8
Two piece mitered surface with 90˚ right angle. To
be used with only 30" high panels to place
countertop no higher than 34" to comply with ADA
guideline 4.32.4 (wheelchair height). Refer to
worksurface height dimensions of
Figure 1
on
page 6. Countertop extends no more than 4" in the
aisle to comply with ADA guideline 4.4.1. Brackets,
which are mounted on inside and outside of
station, include steel locking clips to prevent
dislodgement. Countertop accepts task light on
receptionist side. Clearance between countertop
and 29” high work surface is only 4”.
Note:
If countertop is installed adjacent to an in-
line height change full post, a notch must
be specified on the left, right or both sides
of the work surface.
Figure 2.
Width: 24", 30", 36"
Depth: 16"
Note:
WireWorks ADA Countertops must be
installed on top of a 30” high panel.
Countertops add 3" to the stated height of
the panel; i.e. a 30" high panel supports a
countertop such that the top of the
countertop is 33" above the floor
(assuming that the glides are turned out
1/2”).
Note:
Brackets are positioned on the receptionist
side of the panel. The aisle side of the
panel remains clear of brackets (except for
wheelchair height countertops).
1. Ensure that countertop is the same width as the
panel(s) to which it will be attached.
2. Ensure that the panel top cap and related trim
is installed prior to attaching the countertop.
Top cap cannot be installed after countertop is
installed.
3. Position the brackets such the top of the
bracket is slightly (1/8") above the panel top
cap. Note: Brackets are handed and "L" and "R"
are stamped into the top flange of the brackets.
Figure 1.
ADA lock
Countertop support
bracket (R)
ADA inside
bracket
ADA lock
Figure 1
ADA inside
bracket
Countertop support
bracket (L)
