KI CFS01, Руководство по сборке

Страница: 6 / 20

6
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Monitor Arms - Dual Screen Monitor Arm - Model CFS02
Assembly Instructions
Dual Screen Monitor Arm
Assembly - Model CFS02
1. If pole assembly mounting systems
have not been installed, reference
“Clamp Mounting Systems”
instructions on page 1, or “Drill
Mounting Systems” instructions on
page 2 before continuing (Figure 1).
2. Twist the pole cap off the pole
assembly, but save to place back on
pole once all components have been
installed (Figure 1).
3. Slide the dual hub support ring
down the pole to the desired height
of the monitor screen. Twist knob on
the support ring to secure in place
(Figure 2).
4. Place the dual hub arm assembly
down the pole into position on top of
the dual hub support ring (Figure 2).
5. Mount the trim ring on top of the
dual hub arm assembly followed by
re-installing the pole cap on top of
the pole assembly (Figure 3).
6. Insert monitor cables through
support ring tabs as required
(Figure 4).
7. To properly install monitor screen to
the faceplate of the monitor mount
assembly, reference “Mounting the
Monitor” instructions on page 17.
pole
assembly
worksurface
pole cap
mounting system
(clamp mounting
shown)
Figure 1 Figure 2
dual hub
support
ring
pole
assembly
worksurface
dual hub arm
assembly
front plate
Figure 3
pole
assembly
worksurface
dual hub
support ring
pole cap
trim ring
dual hub arm
assembly