KI CFS01, Руководство по сборке

Страница: 3 / 20

3
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Monitor Arms - Mounting Pole to Worksurface - Drill Mounting System
Assembly Instructions
Note: The monitor arm kit comes
with two different length clamp
bolts, 3
1
/
2
” and 5
1
/
2
” long. The Drill
Mounting System below uses 5
1
/
2
”
bolt.
4. Flip upper clamp bracket upside
down as illustrated in Figures 5 & 6
and position the upper clamp bracket
side-to-side (Figure 5) (with the
flange to face the left or right table
sides) or front-to-back (Figure 6)
over the drilled mounting hole as
illustrated, align and hold in place
from under the worksurface
(Figures 5 & 6).
Note: If upper clamp bracket is
oriented in the front-to-back position
as illustrated in Detail A and a
10-wire rigid wireway is present,
the end of the bracket without the
flange can slide above the wireway
into mounting position as long as it
does not interfere with the electrical
system (Detail A).
5. Slide the clamp knob onto the 5
1
/
2
”
long clamp bolt and tap the bolt head
into the recess in the knob, ensuring
the bolt head is securely engaged
into the knob (Figures 5 & 6).
6. Install the clamp bolt and knob
assembly through the mounting
hole of the upper clamp bracket then
through the drilled mounting hole
(Figures 5 & 6).
7. Position the pole assembly above the
mounting hole with clamp bolt. Align
and twist the threaded end of the bolt
into the pole assembly base, using
the clamp knob to tighten securely
(Figures 5 & 6).
Figure 5
grommet
cutout
pole
assembly
worksurface
(underside)
upper clamp
bracket
(side-to-side)
clamp
knob
5 / ”
1
2
clamp
bolt
Figure 6
grommet
cutout
pole
assembly
worksurface
(underside)
upper clamp
bracket
(front-to-back)
clamp
knob
5 / ” 1
2
clamp
bolt
Detail A
upper clamp
bracket
pole
assembly
clamp
knob
5 / ”
1
2
clamp
bolt
10-wire
rigid
wireway