KI CFS01, Руководство по сборке

Страница: 2 / 20

2
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Monitor Arms - Mounting Pole to Worksurface - Drill Mounting System
Assembly Instructions
Figure 1
pole
assembly
upper
clamp
bracket
Phillips
screw
worksurface
(top)
drill
grommet
cutout
Figure 4
Mounting Pole to Worksurface
using the Drill Mounting System
Note: Drilling a hole through the
worksurface to mount the pole
assembly is an option when the pole
assembly cannot mount to the edge
of the worksurface.
1. Using a Phillips screwdriver, remove
screws attaching the upper clamp
bracket to the pole assembly base
(Figure 1). Set the upper clamp
bracket aside and re-attach screws to
the pole assembly base (Figure 2).
Note: The upper clamp bracket is
used as a template to field locate
where the pole assembly will mount
and to make sure no interference is
present once installed. The bracket
can be oriented side-to-side (with the
flange to face the left or right table
sides) or front-to-back, as long as
the flange faces the user side.
2. Using the upper clamp bracket as a
template underneath the worksurface,
position the bracket’s drill mounting
hole a minimum of 3” away from
the grommet cutout edge and a
minimum of 2
1
/
2
” from the non-user
edge of the worksurface and mark
the location. To prevent the laminate
from peeling, place a piece of tape
over the marked location, then
re-mark desired location on the piece
of tape. Use a
1
/
4
” drill bit in a drill
driver and carefully bore a pilot hole
straight up at the marked location,
all the way through the worksurface
(Figure 3).
3. On the worksurface top, place a piece
of tape over the pilot hole to prevent
the laminate from peeling and mark
hole location. Drill down through
the pilot hole using a
3
/
8
” drill bit in
a drill driver until it goes all the way
through the worksurface (Figure 4).
Figure 2
pole
assembly
Phillips
screw
Figure 3
grommet
cutout
worksurface
(underside)
upper
clamp bracket
(front-to-back
orientation)
flange
drill-mounting
hole
drill