KI CFS01, Руководство по сборке

Страница: 15 / 20

15
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Monitor Arms - Triple Screen Monitor Arm - Model CFS07
Assembly Instructions
pole
assembly
worksurface
pole cap
mounting system
(clamp mounting
shown)
Figure 1
worksurface
mounting system
(clamp mounting
shown)
Figure 2
pole
assembly
hub
bushing
half
hub
bushing
half
beam
half
beam
half
beam
screw
beam
screw
beam
lock nut
bushing
tab
beam
lock nut
Triple Screen Monitor Arm
Assembly - Model CFS07
1. If pole assembly mounting systems
have not been installed, reference
“Clamp Mounting Systems”
instructions on page 1 or “Drill
Mounting Systems” instructions on
page 2 before continuing (Figure 1).
2. If monitor mount assembly has
not been installed to the extension
arm assembly, reference “Monitor
Mount Assembly to Extension Arm
Assembly” instructions on page 4
before continuing.
3. Twist the pole cap off the pole
assembly, but save to place back on
pole once all components have been
installed (Figure 1).
4. To install beam halves to the pole
assembly, first position two hub
bushing halves together around the
pole, with the bushing tabs facing
the user side as illustrated. Next
orient the two beam halves over the
hub bushing halves, aligning the
user side beam mount holes with
the holes in the bushing tabs. Insert
a beam screw through all aligned
mounting holes at the user side
and twist on a beam lock nut. Add
a screw and beam lock nut at the
rear, then tighten back screw and
nut. Position the beam to the desired
height and tighten user side beam
screw and lock washer to secure
beam assembly in place (Figure 2).