MY20K10-02_1.0_10.11.2020
47
Operation
6.14
Display
6.14.1 Attaching the display
1
Place the screen at a 90° angle to the mount on
the handlebars.
2
Turn clockwise.
The display is fully attached when it is upright
and locked into position.
6.14.2 Removing the display
The system – the display and drive system –
should be switched off before the display is
removed. However, nothing will be damaged if
you attach or detach the display while the drive
system is switched on.
Wait for about 30 seconds after removing the
display before switching the display back on
again; otherwise, successful system initialisation
cannot be guaranteed.
1
Turn the display 90° anticlockwise on its
mounting plate.
The electrical connections are disconnected.
2
Remove the display.
The drive system will switch off about
10 seconds after the display is detached. If the
light was on, it will also switch off after about
15 seconds.
6.14.3 Using the main beam
The drive system needs to be switched on first to
turn on the
main beam
.
Press
main beam button
briefly.
The
main beam
is switched on and the
main
beam symbol
is displayed on the
main beam
button
.
Press
the main beam button
briefly again.
The
main beam
is switched off and the
main
beam symbol
is displayed.
6.14.4 Selecting the level of assistance
Press the
plus button
.
The level of assistance is increased.
Press the
minus button
.
The level of assistance is reduced.
The set level of assistance is shown on the
display.
6.14.5 Switching on recovery
Recovery can only be activated within a speed
range between 6 and 45 km/h. Recovery cannot
be activated when the vehicle is stationary or
travelling at under 6 km/h.
The battery cell temperature must be higher than
0 °C to switch on recovery. Recovery is
automatically deactivated under 0 °C.
The battery charge level must be higher than 10%
to switch on recovery. The lower the battery level
is, the harder braking is due to recovery.
Press the
minus button
repeatedly until you
reach level of assistance 0.
Use the
minus button
to switch down one level
further from this level.
Recovery will work at a low power output at
level 1.
Use the
minus button
to switch down one level
further.
Recovery will work at a high power output at
level 2.
6.14.6 Switching off recovery
Press the
Plus button
repeatedly until you
reach level of assistance 0.
Recovery is now switched off.
Notice
Do not use the display as a handle. The
display may become irreparably damaged if
you use it to lift the S pedelec.
Remove the display from its mount if the
S pedelec is not going to be used for several
weeks. Store away safely in a dry environment
at room temperature.
