MY20K10-02_1.0_10.11.2020
46
Operation
6.13
Electric drive system
6.13.1 Switching on the electric drive
system
A sufficiently charged battery has been inserted
into the S pedelec.
The battery is firmly positioned. The key has been
removed.
Press on the
On-Off button (battery)
to wake
the battery up from sleep mode.
Press the
On-Off button (control panel)
for
about one second.
The initialisation process is completed after
about five seconds and the display shows the
trip screen.
The S pedelec is ready for use.
6.13.2 Switching off the electric drive
system
Press the
On-Off button (control panel)
on the
control panel for about 1 second.
The display and drive system are switched off.
You will not cause any damage if the screen is
removed without switching off the system.
6.13.3 Placing the battery in sleep mode
1
Press the
On-Off button (battery)
down for
more than 5 seconds.
The LEDs will go off one by one.
2
When the last LED has gone out, press the
On-Off button (battery)
for about 2–3 seconds
more.
The battery will go into sleep mode in the next
60 seconds.
6.13.4 Waking the battery up from sleep
mode
1
Press the
On-Off button (battery)
briefly.
All 5 LEDs will go on initially, followed by a brief
pause, after which all LEDs will flash briefly
three times. The battery is ready to operate
again.
Crash caused by lack of readiness for braking
When it is switched on, the drive system can be
activated by the application of force on the
pedals. There is a risk of a crash if the drive is
activated unintentionally and the brake is not
reached.
Never start the electric drive system, or switch
it off immediately, if the brake cannot be
reached safely and reliably.
CAUTION
!
Notice
The battery is automatically placed in sleep
mode if it is not used (display switched off, the
battery button not pressed). When the battery
is in this state, the standby power consumption
is reduced to a minimum, thus allowing longer
storage periods without major loss of capacity,
for example.
