Kessel Aqualift S Compact, Инструкция по установке и эксплуатации

Страница: 26 / 100

EN
4.5 Installation example white tank (floor slab with waterproof concrete)
1 Aqualift S
2 Extension section with central flange
for installation in waterproof con-
crete, art. no. 83075
a Floor covering f Insulation
b Waterproofing
layer
g Blinding layer
c Screed h Control unit
d Concrete floor i Pressure pipe
e Insulation BWS
*)
design
water level
*) Maximum groundwater level to be
expected, max. 3 m allowable.
4.6 Installing the cable conduit and inlet pipe
Cable conduit (DN50) connection socket
The cable conduit must be installed with max. 45° bends.
Check whether the seal is in the socket.
Insert the socket mating part into the pre-drilled opening
from the inside.
Screw the socket hand-tight onto the mating part so that
tightness is guaranteed.
Slide the pipe in as far as it will go.
Repeat these steps again for the inlet.
Installing the inlet pipe
Push sewer pipe with double socket (DN100) or PE weld-
ing socket onto preassembled inlet socket (opposite
cable conduit) and connect securely.
Check the positioning of the tank and for tight fit of the
connection on the inlet socket.
Install additional pipes (max. DN100) if necessary
Additional connections (additional inlet, ventilation pipe)
must be installed at least at the height of the predrilled
inlets. Only the marked areas shall be drilled.
If no ventilation takes place through the cover plate, a
separate ventilation pipe must be laid (above the roof).
Draw in desired connections, check alignment.
Select drill with a suitable hole saw (art. no. 500101).
Have an appropriate seal for the pipe penetration at the
ready (available as accessory).
Drill the hole and install the seal as described in the hole
saw instructions.
26 / 100 Lifting station/Installation and operating instructions 016-059