Single-axis weed brush Weedo II
Error! Use the Home tab to apply Überschrift 1 to the text that you want to appear here.
DE
7.14Swing the weed brush around the transverse axis
Fig.: Swing the weed brush around the transverse axis
1
Clamping lever
2nd Bolt handle
3rd
Brush plate holder
The angle of inclination of the brush plate in the direction of travel can be
determined at seven locking positions arranged in an arc.
The adjustment is made as follows:
1.
Turn the clamping lever (1) slightly counterclockwise.
2nd. Loosen the locking bolt by pulling out and holding the bolt handle (2).
3rd. Swivel the brush plate holder (3) until the desired angle of inclination is
reached. The brush plate moves around the transverse axis.
4th. Release the bolt handle (2) so that the bolt engages in a hole.
5.
Tighten the clamping lever (1) clockwise.
By swiveling the weed brush around the transverse and longitudinal axes (see
chapter 7.15 Swing the weed brush around the longitudinal axis on page ) the point
of contact of the weed brush with the ground can be set. The uniaxial weed brush
can thus be switched to driving on the left. Corresponding setting
recommendations are in the chapter7.10 Requirements for optimal weed removal
on page given.
Item: 81 / Instructions / 7 Operation / Kersten / Weedo II / 7.5 Swiveling the WKB around the longitudinal axis @ 14 \ mod_1548254206370_6.docx @ 253582 @ 2 @ 1
2019-03-01
58 / 79
Содержание Weedo II
Страница 2: ...DE 2019 03 01 2 79...
