Kenwood TS-990S, Инструкция по эксплуатации

Страница: 283 / 290

TROUBLESHOOTING 18
18-13
Index Contents
SYMPTOMS ENCOUNTERED DURING RECORDING AND PLAYING
Symptom Common Problem What to do Ref. Page
The message appears when [ ] is pressed
during the timer recording.
Timer recording is in process. Press and hold [(BREAK)] (F4) to
abort the timer recording and allow the
transceiver to be operable. To continue
the timer recording, press [ ].
{page 15-5}
As a result of the timer recording, no sound is
audible from the recorded file.
Mute was active during the timer recording. Be sure that the mute is inactive during
the timer recording. While the muting
capability is active, the received audio
cannot be recorded.
{page 4-7}
Voice message cannot be recorded. The audio source is not configured as desired. Be sure that the audio source is correct
and the input signal level is appropriate.
{page 13-1}
The repeat interval of the voice message
does not function.
You attempt to use the repeat interval only for
playing of the voice message.
The repeat interval can function only
when the voice message is played
during the transmission. This does not
function only for playing.
{page 13-3}
Repeating is disabled. Enable the repeating for the channel
you wish to repeat.
{page 13-3}
The received audio can be recorded only for
30 seconds.
The received audio is recorded to the internal
memory.
Use the USB flash drive to store the
received audio.
{page 12-1}
Full time recording is selected. The maximum recording time for the
Full time recording is 30 seconds
despite of the destination.
{page 13-5}
WAV file cannot be played. The audio file has different file format than what
the transceiver can play.
The transceiver can play the audio file
with the following format.
Number of channels: 2, Number of bit:
16, sampling frequency: 16 kHz
Audio file cannot be deleted. The file is the delete protected. Cancel the delete protection.
{page 13-10}
The volume to play (reception) is small. Rotate the AF (M) control counterclockwise. Rotate the [AF] (M) control clockwise
to adjust.
{page 4-7}
The volume to play (transmission) is small. Rotate the AF (S) control counterclockwise. Rotate the [AF] (S) control clockwise
to adjust.
{page 4-7}
No signal is entered from the OPTICAL IN
connector.
The sampling rate of the transceiver does not
march the sampling rate of the sourcing device.
The sampling frequency for the entered
signal is 44.1 kHz and 48 kHz, the
number of bit is 24 or 16.
{page 2-9}
No signal is entered from the OPTICAL OUT
connector.
The sampling rate of the transceiver does not
march the sampling rate of the target device.
The sampling frequency for the signal
to be transferred is 48 kHz, the number
of bit is 24.
{page 2-9}