Kenwood TS-990S, Инструкция по эксплуатации

Страница: 83 / 290

5-5
ASSISTING YOUR SMOOTH QSO 5
Index Contents
COPYING THE AGC TIME CONSTANT
CONFIGURATIONS
The AGC time constants configured for “FAST”, “MID” and
“SLOW” of the main band can be copied to the sub band.
Also, the AGC time constants configured for “FAST”, “MID”
and “SLOW” for the sub band can be copied to the main
band.
[F1]~[F7] [AGC OFF](M) [ESC]
[AGC/SEL](S)
[AGC/SEL](M)
[AGC OFF](S)
1 Press one of the mode keys to select the mode, other
than FM mode, for the main band or sub band to be a
copy source.
2 Press and hold [AGC/SEL] (M) or [AGC/SEL] (S) to
open the AGC screen.
3 Press [COPY] (F7) to copy the parameter for the AGC
time constant.
The message prompting you to confirm that the AGC time
constants, configured for “FAST”, “MID” and “SLOW” of the
main band or sub band can be copied to the other band will
appear.
4 Press [OK] (F4).
The AGC time constant is copied. Press [CANCEL] (F7) to
finish the process without copying.
5 Press [ESC] to exit.
Note:
◆ Not only the time constant value but also the time constant value
displayed on the AGC screen are copied.
DISABLING THE AGC
If the received signal strength is sufficiently high and is
stable, you can disable the AGC. In general, disabling the
AGC function decreases the RF gain; however, this will
facilitate you listening to a weak signal.
Follow the procedure below to disable the AGC for the
main band and sub band independently.
PRECAUTION
◆ Depending on reception conditions, disabling the AGC may cause
the audio to be excessively loud, both through the internal speaker
and a set of headphones.
1 Press [AGC OFF] (M) or [AGC OFF] (S) to disable the
AGC.
The message prompting you to disable the AGC appears.
2 Press [OK] (F4) to disable the AGC.
Pressing [CANCEL] (F7) to abort this operation