INSTALLATION MANUAL
– install
Slim Jim Installation manual
page 11
Connect to drain/waste
•
Normally, the drain hose of the machine will already be mounted onto the machine. The drain
hose of the drip-tray is not yet mounted.
o
Slide a hose clamp over the separate drain hose.
o
Push the end of that drain hose onto the pipe of the drip-tray and tighten the hose clamp.
•
Lead the two drain hoses to the waste of the location (with water lock!). To prevent clogging
and/or pinching, make sure the hoses slope down all the way between the machine and the waste
and make sure the hoses do not make a sharp bend or are led over a sharp angle.
•
The drain runs off best when the end of the hose is above water-level in the water lock.
Figure 6. The drain hoses should not slope up (left) or make a sharp bend (centre).
Connect pump cable
Danger
If the pump connection cord is damaged it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
•
Connect the female plug on the pump-cable to the male plug at the pump.
•
Tighten the plugs with the latching ring (turn clockwise).
Figure 7. Plug the pump-cable onto the pump-motor and secure latching ring.
machine
machine
machine
waste
waste
waste
espresso
machine
pump motor
latching
ring
