INSTALLATION MANUAL
– install
Slim Jim Installation manual
page 10
Connect to water supply
Rated pressure:
0.1-0.5 MPa (1-5 bar)
Rated flow:
minimum 4 litre/minute
The machine is equipped with a non-return valve that prevents water flowing back to the pump. The
pump itself does not have a non-return valve.
Note!
When installing a new machine, always use new water supply hoses.
Do not re-use the hoses from a replaced machine.
•
Connect water tap to the inlet of the water treatment system with a suitable hose (not included).
•
Make sure the water treatment system has been flushed according to the manufacturers
specifications.
•
Close water mains.
•
Use one of the supplied high-pressure hoses to connect the outlet of the water treatment system
to the inlet of the pump. The connection on the hose is a 3/8
” BSPP swivel-nut.
Note!
National rules/regulations may apply when the appliance is connected to the water mains.
•
Mount the high-pressure hose that is connected to the machine onto the outlet of the pump.
•
Open water mains.
As there now is water mains pressure onto the machine, the coffee boilers will start to fill while
compressing the air inside the coffee system.
Figure 5. Showing the water connections on the pump. Water mains will be attached to water
treatment system (not shown in the photo) and from there via the pump onto the espresso machine.
Note that the water treatment system and supply hose are NOT included in the shipment.
espresso
machine
water
treatment
system
in
out
