HD Intelligent Speed Dome Camera
User Manual
36
Shield Area
After configuring shield area,
the system will shield moving targets entering the area,
and there is no shield area by default. Usually, it‟s unnecessary to configure shield
area; if the scene is special, for example, there is some scene or thing prone to
cause defocus, user can configure shield area to shield it.
Note: The number of guard area, face guard area or shield area is maximum 4, and
none of the area could be too small. The areas should be large enough to hold
the whole person or vehicle.
The configuration steps of guard area, face guard area and shield area are as follows:
Add
1)
Go
to Intelligent > Settings > Arming
, select “Disable” and click “Save”.
2)
Go to
Intelligent > Settings > Guard Area
, and select a preset from the dropdown
list.
3)
Click “Add” to add guard area or face guard area or shield area, and left click on the
image to select 3~20 vertexes and right click to form a closed area.
4)
After editing, c
lick “Save” and the guard area or face guard area or shield area will
be added successfully.
5)
After finishing configuration of the guard area, perform arming configuration to
realize the purpose of excluding interference. Go to
Intelligent > Settings >
Arming
, and configure by actual requests. Please refer to chapter 4.2.5 for details.
Full Area Guard
Click “Full Area” and the system will detect the full image as guard area.
Delete
Select the guard area or face guard area or shield area to be deleted and click
“Delete” to clear this area.
Reset
Click “Reset” to restore to default configuration of guard area.
4.2.5
Arming
The camera will capture and analyze moving targets such as people, vehicles or
non-motor vehicles entering the guard area according to the arming durations.
Configuration steps are as follows:
1) Go to
Intelligent > Settings > Arming.
