KBL Tower pureENERGY 5.0, Руководство по эксплуатации

Страница: 36 / 56

O p e r a t i n g I n s t r u c t i o n s | KBL Tower pureEnergy 5.0
36
CLEANING AND DISINFECTION
WARNING
Risk of Infection.
Risk of Infection by transferring through
skin contact.
• After each tanning session the tanning
device must be cleaned and disinfected
with a cleaning and disinfectant agent.
• Use only EPA registered quaternary
ammonium germicidal based detergent
solution (follow product label for use-dilu-
tion), such as Lucasol One Step, to clean
and disinfect the tanning device and its
components.
• For thorough cleaning and disinfection,
the product must be allowed to remain
in contact with the surface being cleaned
and disinfected for a specified amount
of time. This specified amount of time
depends on the cleaner/disinfectant
which is used. Follow the directions for
use of the cleaner/disinfectant. After this
specified application time remove remain-
ing cleaner/disinfectant from the surfaces
of the tanning device. Use a single-pass
paper towel.
• If the device is determined not to be visu-
ally clean at the end of the cleaning step,
the relevant previous cleaning steps must
be repeated so that a visibly soiled device
is not used again. Removal of residual soil
ensures the effectiveness of the disinfec-
tion process and reduces the risk of infec-
tion to users of the device.
ADDITIONAL CLEANING ACTIVITIES
WARNING
These cleaning works must be car-
ried out by qualified, trained and
authorized service technicians.
Every 6 months
Make sure that the inside and outside of the tan-
ning device is cleaned and free from dust, fluff or
objects.
Inadequate cleaning leads to overheat-
ing. As a result, this can lead to damage
the tanning device!
Signs of electrical overstress
Check the cables and connections on signs
of electrical overstress.
• Discoloration
• Deformations
• Melting
• Blisters on the housing
The affected components shall be replaced
immediately! Use only OEM spare parts.
Check that all connectors are plugged
into the socket housing to the end stop.
Click