Kathrein UFS 903 sw, Руководство по эксплуатации

Страница: 14 / 124

14
When fi tting the connector, make sure that no strands of the braid are touching
the inner conductor, otherwise a short circuit will occur.
The quality of the reception signal depends on a good connection at this point!
Connection and setup
Connect the Sat IF input on the receiver to the satellite reception system.
Use a coaxial cable with a standard F connector.
If the F standard connectors have not yet been fi tted on the cables, strip
the insulation from the cables as shown in the following illustration and
carefully screw the F standard connectors on to the ends of the cables to form
a secure attachment.
Make sure that your own satellite antenna system is equipped for digital reception
in the high-band range with at least one universal LNB.
The presets for the control signals have been made for standard reception systems, i.e. 14/18 V for
polarity reversal and 22 kHz switching signal for low/high band changeover on multi-feed reception
systems.