Kathrein UFS 641si, Руководство по эксплуатации

Страница: 53 / 84

53
Satellite
Select the satellite to be searched, using the

buttons. Make sure your reception system is
aligned to the selected satellite. You can search only one satellite at a time. If you have connected
a multi-feed reception system (e.g. reception of ASTRA 19.2° East and HOTBIRD 13° East), you
must repeat this procedure for each satellite. You can however also start the
fi rst installation again,
in the course of which a channel search of all the satellites you selected is performed.
Press the

button to move to the next selection item.
Channel Search Mode
Use the

buttons to select whether you want to search “free & scrambled” or “only free” channels.
Press the

button to move to the next selection item.
Network Search
Use the

buttons (On/Off) to select whether a network search should be performed. If
you set the “Network Search” to “Off”, only the factory stored transponders of the satellites you
previously selected will be searched for new as yet unlisted channels.
If you set the “Network Search” to “On”, the transponder network enables additional transponders
that have not yet been stored to be located. They are then stored and searched for new channels in
the same way as the existing transponders.
When you have made your settings, use the

buttons to select “Start Search” and press the

button to start scanning. You can cancel the search at any time by pressing the

button.
During the search you will see the following on-screen display (example):
TV channels
found
Radio channels
found
Progress bar
Satellite with the
transponder
currently being
searched
SEARCH CHANNELS (CHANNEL SEARCH)