Kathrein UFS 641si, Руководство по эксплуатации

Страница: 12 / 84

12
Place the two mounting pieces on your
receiver as shown in Figures 1-3. During
the process the following should be taken
into account:
1. Left (L) and Right (R) markings (see
arrows Figure 2)
2. The teeth on the underside of the
mounting pieces must be inserted in
the
fi rst and last row of the ventilation
slots on the top of the receiver (see
arrows Figure 1)
Now hold the receiver, with the installation kit attached, at
the installation location. Screw in the wood screws supplied
through the smaller holes in the screw attachment area (4 x)
(see Fig. 4). Wherever possible, use the wood screws supplied.
If these are unsuitable, other screws of adequate size and
strength can be used.
Under no circumstances however
use countersunk wood screws, since these can damage
the attachment area (see Fig. 5).
Then screw all four screws fully home, so that the installation
kit is no longer able to come free.
SUSPENDED INSTALLATION
INSTALLATION ON A FIXED FLAT SURFACE
So as to prevent the receiver slipping or falling, the mounting kit can also be attached to the underside
of the receiver. Assembly is the same as for suspended installation, except that the mounting kit is
attached to the underside of the receiver.



Remove the wood screws supplied from their transport attachment on the top of the respective mounting
piece (2 pieces).

Screw attachment
left
right

↓
↓
↓
↓
↓
↓
↓
↓
↓
CONNECTION AND SETUP
For subsequent disassembly it is suf fi cient to undo all screws one turn each and
to push the receiver to the right (suspended) or left (on top) to release it.