Kathrein UFD 516, Руководство пользователя

Страница: 9 / 40

Functions of the Remote Control
9
Functions of the Remote Control
You switch the receiver on from stand-by with the red button or with a
numerical button [ 0 ]-[ 9 ].
The buttons [ ◄ ] [ ► ] and [ ▲ ] [ ▼ ] arranged around the [OK] button
have control functions (cursor/bar) in the menus.
Button Designation
in the menu
MENU ME Selection of main menu
TEXT TE See channel arrangement / pool
FAV FA Selection of the favourite bank
PIP PI TV switching voltage and channel
arrangement / pool
OPT OP Audio mode and channel arrangement
TV/R TV TV / radio switchover and channel
arrangement
i i Banner display (or signal and
channel parameters)
EXIT EX Last programme or exit from menu
EPG EP EPG selection
II II Marking channels with ? = parental
control
■
Switching over to transparency and
back into menus
Red button Selection of the TIMER menu
Transfer of a programme from EPG into
the timer menu
◄►▲▼ Cursor Control of the bars in the menu
Command set of the remote control
4 devices can be addressed in connection with the remote control RC
660.
Basically command set 1 of the receiver is set in the factory.
If you operate only one receiver and should the active command set
have been switched over by faulty operation, so that the receiver can
no longer be operated, the remote control can be switched back into
command set 1 without difficulty.
Programming:
Address 1: Press EXIT + 9 + 1 buttons simultaneously
Address 2: Press EXIT + 9 + 2 buttons simultaneously
Address 3: Press EXIT + 9 + 3 buttons simultaneously
Address 4: Press EXIT + 9 + 4 buttons simultaneously
You must point the remote control to the receiver in this case.
Switching over RC 660:
Address 1: Press EXIT + 1 buttons simultaneously
Address 2: Press EXIT + 2 buttons simultaneously
Address 3: Press EXIT + 3 buttons simultaneously
Address 4: Press EXIT + 4 buttons simultaneously