Katadyn PowerSurvivor 40E, Руководство пользователя

Страница: 25 / 37

25
holes in the drive assembly bracket over the studs projecting from the pump back plate. Insert
the coupling pin through the aligned holes in the slider shaft and piston shaft. Push the rubber
boot over the coupling pin to hold it in place.
12. Install the four hex nuts on the studs projecting from the pump back plate through the drive
assembly bracket and tighten evenly with a 1/2" open-end wrench and 1/4" allen wrench.
Do not over tighten these fasteners!
13. To replace the o-rings beneath the cleaning valve assembly, refer to Figure R-9 . Unscrew the
two socket head cap screws using
a 5/32" allen wrench and
remove the assembly from the
pump body. Remove old o-rings
(8012594) and (8012697) and
replace them with new o-rings
from the
RSK
. Replace the
cleaning valve assembly on the
pump body and install the two
cap screws. This completes the
procedure for reassembly of the
watermaker. When operation is
commenced again, carefully
inspect the watermaker for proper
operation and any leaks or other
signs of incorrect assembly.