STEP SEVEN
Position the Bottom Screen (Part #B9) over the float
so the motor housing (can) passes through the large
hole in the center of the screen. Remove the center
three 3/8” Lock Nuts from the 9” Bolts and place the
Bottom Screen Clips (Part #B13) over the bolts as
shown. The power cord can be slid under the bottom
screen between the float and screen where two float
sections come together
before the 3/8” Lock
Nuts are replaced. Re-
place the three inside
Lock Nuts and tighten
all 3/8” Lock Nuts us-
ing the 9/16” wrench
and socket.
Note: Extra hardware
may be included
STEP EIGHT
Return the unit to its upright position and select a
nozzle (See page 13 for Nozzle and Pattern Options).
Insert the Shaft Bolt (Part #D2) into the Nozzle Head
so it fits snugly into the molded socket for those noz-
zles that use the bolt. Install the Nozzle by threading
it into the inner cone of the pump. Make sure to
tighten the Nozzle all the way down.
To install the Redwood nozzle, make sure the Y In-
sert (Part #D4) is installed and seated properly into
the Nozzle Housing (Part #D7). Push the nozzle
down over the cone assembly (it may require light
taps with a rubber mallet to seat properly). Next, use
the 3 Self Tapping Screws (Part #D1) provided in the
3 holes on the nozzle and tighten the screws into the
cone assembly. Once you feel resistance, two more
turns will be sufficient. To install the Spruce nozzle,
follow the same steps, but do
not install the Y Insert.
STEP NINE
All 5.1JF power cords have a watertight Quick Dis-
connect and the power cord is shipped separately. It
should now be attached to the stub cord by lining up
the male and female halves of the disconnect and
hand tightening the blue collar. The Additional
Strain Relief should be attached to one of the lower
float brackets as pictured. If there is not Strain Re-
lief, use the Nylon Cable Tie provided to secure the
cord to a rope to prevent damage by the propeller.
Double check the Quick Disconnect to make sure the
threaded collar has not come loose in shipping before
placing in the water. If installing a new Quick Dis-
connect, please refer to Quick Disconnect instruc-
tions. Also, at this time, lights can be installed if pur-
chased.
STEP TEN
Use the ropes to position the Fountain in the desired
location in the pond/lake. Anchor the ropes or secure
them to the shoreline so the ropes are free of slack,
but not tight. To prevent twisting of the unit due to
torque, you should place the anchor at least 3 feet
from the float for each foot of depth (Ex. A 6 foot
deep pond would require an anchor 18 feet horizon-
tally from the float.)
11
Pictures correspond
with Step Six on
previous page
