STEP SEVEN
Position the Bottom Screen (Part #B9) over the float
so the motor housing (can) passes through the large
hole in the center of the screen. Remove the center
three 3/8” Lock Nuts from the 9” Bolts and place the
Bottom Screen Clips (Part #B13) over the bolts as
shown. The power cord can be slid under the bottom
screen between the float and screen where two float
sections come to-
gether before the
3/8” Lock Nuts are
replaced. Replace
the three inside Lock
Nuts and tighten all
3/8” Lock Nuts using
the 9/16” wrench and
socket.
Note: Extra hardware may be included
STEP EIGHT
Return the unit to its upright position and select a
nozzle (See page 13 for Nozzle and Pattern Options).
Insert the Shaft Bolt (Part #D2) into the Nozzle Head
so it fits snugly into the molded socket for those noz-
zles that use the bolt. Install the Nozzle by threading
it into the inner cone of the pump. Make sure to
tighten the Nozzle all the way down.
To install the Redwood nozzle, make sure the Y In-
sert (Part #D4) is installed and seated properly into
the Nozzle Housing (Part #D7). Push the nozzle
down over the cone assembly (it may require light
taps with a rubber mallet to seat properly). Next, use
the 3 Self Tapping Screws (Part #D1) provided in the
3 holes on the nozzle and tighten the screws into the
cone assembly. Once you feel resistance, two more
turns will be sufficient. To install the Spruce nozzle,
follow the same steps, but do
not install the Y Insert.
STEP NINE
On power cord lengths of 100 feet or longer with the
watertight Quick Disconnect, the power cord is
shipped separately. It should now be attached to the
stub cord by lining up the male and female halves of
the disconnect and hand tightening the blue collar.
On these cords, the Additional Strain Relief should be
attached to one of the lower float brackets as pic-
tured. If there is not Strain Relief, use the Nylon Ca-
ble Tie provided to secure the cord to a rope to pre-
vent damage by the propeller. Double check the
Quick Disconnect to make sure the threaded collar
has not come loose in shipping before placing in the
water. If installing a new Quick Disconnect, please
refer to Quick Disconnect instructions. Also, at this
time, lights can be installed if purchased.
STEP TEN
Use the ropes to position the Fountain in the desired
location in the pond/lake. Anchor the ropes or secure
them to the shoreline so the ropes are free of slack,
but not tight. To prevent twisting of the unit due to
torque, you should place the anchor at least 3 feet
from the float for each foot of depth (Ex. A 6 foot
deep pond would require an anchor 18 feet horizon-
tally from the float.)
7
Pictures correspond
with Step Six on
previous page
